Generator For Stator Honda XR 650 L 1993-2013 Kawasaki Vulcan ZX6 ZX9

Home/ATV CITY/Stator/Charging Coils/Generator For Stator Honda XR 650 L 1993-2013 Kawasaki Vulcan ZX6 ZX9

Please call before visiting our unit in Ilfracombe - 01271 320727

Generator For Stator Honda XR 650 L 1993-2013 Kawasaki Vulcan ZX6 ZX9

£133.30 Excluding VAT | (Price with VAT : £159.96)

2 in stock

RM01021

2 in stock

SKU: RM01021 Categories: , ,

Description

Brand new stator

You must re-install your original grommet and the new connector (see picture).

Once your connector and grommet is re-installed, our part becomes a Plug-and-play unit, direct fit, and very easy to install.

Highest grade lamination materials

Highest grade copper windings, resistant to 200 degrees Celsius.

Connector included

All product shipped are tested

One year limited warranty

We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues.

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Minimal Mechanical Experience Required

Reviews

There are no reviews yet.

Be the first to review “Generator For Stator Honda XR 650 L 1993-2013 Kawasaki Vulcan ZX6 ZX9”

Your email address will not be published. Required fields are marked *

Number of wires : 3
Number of terminals : 3
Alternator : White between each White = 0.4 ohms+/-20%
Alternator : White to Ground = O.L. ON DISPLAY

Before installing your new stator

Check the AC output of the stator.

Replace any burned or corroded connectors on stator and regulator/rectifier

Check and repair any melted wiring.

Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".