Stator Ski-Doo 1987-1990 (Alpine Citation Escapade Formula MX Formula Plus Nordik Safari Tundra )

Home/ATV CITY/Stator/Charging Coils/Stator Ski-Doo 1987-1990 (Alpine Citation Escapade Formula MX Formula Plus Nordik Safari Tundra )

Please call before visiting our unit in Ilfracombe - 01271 320727

Stator Ski-Doo 1987-1990 (Alpine Citation Escapade Formula MX Formula Plus Nordik Safari Tundra )

£157.00 Excluding VAT | (Price with VAT : £188.40)

Out of stock

 

Out of stock

SKU: RM01099 Categories: , ,

Description

Brand new stator

Direct replacement to your original unit

Plug-and-play, direct fit, easy installation.

Highest grade lamination materials

Highest grade copper windings, resistant to 200 degrees Celsius.

Pick up pulsar coil included

Connector included

Rubber grommet included

Back Plate included

All product shipped are tested

One year limited warranty

**Our 15 years experience advise to:
Before purchasing our replacement stator please compare the picture from our add to your original part.
With these older sleds sometimes the motor or part has been swapped out, the best way to make sure is visually.

*All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Plug-and-Play / Direct Fit

Reviews

There are no reviews yet.

Be the first to review “Stator Ski-Doo 1987-1990 (Alpine Citation Escapade Formula MX Formula Plus Nordik Safari Tundra )”

Your email address will not be published. Required fields are marked *

Black/Red to Black = 73 OHMS
Yellow/Brown to Yellow = 0.5 OHMS
Black/Yellow = Ground
Before installing your new stator

Check the AC output of the stator.

Replace any burned or corroded connectors on stator and regulator/rectifier

Check and repair any melted wiring.

Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.

When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010".